revision 6/21/2012 www.phihong.com 8 -port 95w per port midspan mega power over ethernet midspan features ? proprietary detection (12.5k), disconnect and overload protection ? fully compliant detection, disconnect and voltage control per ieee802.3at ? snmp v2c management ? gigabit compatible ? mega poe 95w per port ? full protection ocp, ovp ? diagnostic leds ? limited power source ? 1u rack mounting k it ships with unit ? 1 year warranty applications ? wireless access points ? security systems ? computer workstations ? ip cameras ? kiosks ? magnetic locks safety approvals ? ce ? cul/ul mechanical characteristics ? length: 438mm (17.25in) ? height: 44.5mm (1.75in) ? width: 228mm (8.98in) ? 3.8kg (8.5lbs) output specifications note (1): model without snmp management available upon special request. note (2): max load applies to compliant load at 12.5k detecti on. if operating at 25k ?ieee802.3at mode? max load is 0.6a phihong is not responsible for any error, a nd reserves the right to make changes wit hout notice. please visit our website at www.phihong.com for the most up-to-date spec ifications and cont act information. model (1) dc output voltage load output power per port min. max. (2) POE806U-8MP-N-R 56v 15ma 1.69a 95w
poe806u-8mpn characteristics www.phihong.com input: ac input voltage rating 100 to 240vac ac input voltage range 90 to 264vac ac input current 15.0a (rms) 90vac at maximum load 10.0a (rms) 230vac at maximum load ac input frequency 47 to 63hz leakage current < 3.5ma maximum at 264vac, 60hz max in-rush current: 30a for 115vac at maximum load 60a for 230vac at maximum load (cold start at ambient 25c) output: total output power 95w per port 760w maximum total power ripple (p-p) 250mv maximum efficiency 75% (typical) at maximum load, and 120vac 60hz hold-up time 16ms min. 120vac and maximum load transient o/p voltage protection 60v maximum at switch on and off at any ac line phase turn-on delay time (for poe detection) 20 sec maximum at maximum load, 120vac 60hz environmental temperature operation 0 to +40c non-operation -25 to +65c humidity operation 5 to 90% non-operation 5 to 90% emc en55022 class a, fcc class a with utp cabling en55022 class b, fcc class b with ftp cabling isolation test primary to secondary: 4242vdc for 1 minute primary to ground: 2121vdc for 1 minute secondary to ground: 2121vdc for 1 minute immunity en50082-1 esd: en61000-4-2 level 3 rs: en61000-4-3 level 2 efp: en61000-4-4 level 2 surge: en61000-4-5 level 3 cs: en61000-4-6 level 2 voltage dips: en61000-4-11 harmonic: en61000-3-2 class a ieee802.3af/at interoperability if 25k ohm is detected then the unit operates in ?ieee802.3at mode? 33.6w 2 pair powering. 12.5k detection resistance required for full power 95w/port. over-voltage/current, sh ort circuit protection outputs equipped with short circuit protection and overload protection as per 802.3af specification except at maximum average cu rrent is 1.69a the output can be shorted permanently without damage over temperature protection automatic shutdown without damage indicators solid green led: power detected ?on? flashing green: ieee802.3at or (af) detected yellow led: fault detected snmpv2c management port interface nic interface for remote management via secure ip access input connector (standard model) ac input iec320 c14 output connection 4-pair powering for full power pins 3,6, 4,5(+) pins 1,2, 7,8 (-) 2-pair powering for ieee802.3at mode pins 3,6(+) pins 1,2 (-) warranty 1 year
poe806u-8mpn dimension diagram unit: mm www.phihong.com
|
